HY225Wear-resistant and anti-corrosion repair glue
HY225 wear-resistant and anti-corrosion repairing agent is a brushable ceramic repairing agent. Pre-protective coating and other repairs.
Product details
HY225 wear-resistant and anti-corrosion repairing agent is a brushable ceramic repairing agent. Pre-protective coating and other repairs.
![](/Upload/1650067900.jpg)
Instructions
1. Surface treatment: Grind and roughen the surface to be repaired to a depth of more than 1mm and then clean it with HY755 cleaning agent or acetone. The surface to be trimmed must be clean, free of water and oil.
2 Mixing: Weigh components A and B according to the specified weight ratio, and mix them thoroughly to make the color completely consistent.
3 Coating: Use a rubber knife to apply the matched anti-corrosion repair agent to the surface to be repaired. You can apply a small amount first, press it repeatedly with a rubber knife, and then apply the remaining repair agent after fully infiltrating, leaving a margin for processing.
4. Curing: After curing at room temperature for 12 hours, all kinds of mechanical processing can be carried out. When the ambient temperature is lower than 15, the curing time can be appropriately extended. Holding at 80℃ for 3 hours can shorten the curing time and obtain good coating properties.
Product specifications: 500g/set, 12 sets/box.
![](/Upload/1650067900.jpg)
Instructions
1. Surface treatment: Grind and roughen the surface to be repaired to a depth of more than 1mm and then clean it with HY755 cleaning agent or acetone. The surface to be trimmed must be clean, free of water and oil.
2 Mixing: Weigh components A and B according to the specified weight ratio, and mix them thoroughly to make the color completely consistent.
3 Coating: Use a rubber knife to apply the matched anti-corrosion repair agent to the surface to be repaired. You can apply a small amount first, press it repeatedly with a rubber knife, and then apply the remaining repair agent after fully infiltrating, leaving a margin for processing.
4. Curing: After curing at room temperature for 12 hours, all kinds of mechanical processing can be carried out. When the ambient temperature is lower than 15, the curing time can be appropriately extended. Holding at 80℃ for 3 hours can shorten the curing time and obtain good coating properties.
Product specifications: 500g/set, 12 sets/box.